+7 (812) 309 34 73. Договоримся!
Общая информация (S5720-56C-HI-AC)
Huawei S5720-56C-HI-AC is advanced Gigabit Ethernet switch that provides rich agile features, based on Huawei Versatile Routing Platform (VRP). With forty-eight Ethernet 10/100/1,000 ports, and four 10 Gig SFP+, the switch provides the ubiquitous service function to ensure consistent user experience. The Super Virtual Fabric (SVF) function virtualizes the entire network into one device. In addition, the switch supports flexible Ethernet networking, comprehensive VPN tunnel solutions, various security control methods, intelligent deployment, and simple operation and maintenance. The S5720-56C-HI-AC switch is the best choice for the branches of high-quality large- and middle-sized campus networks.
Быстрые спецификацииs
На рисунке 1 показан внешний вид Huawei S5720-56C-HI-AC switch.
Таблица 1 показывает Быстрые спецификацииs.
|
Product Code |
S5720-56C-HI-AC |
|
Ports |
· 48 Ethernet 10/100/1,000 POE+ ports · 4 x 10 Gig SFP+ |
|
Memory (RAM) |
4 GB |
|
Flash |
400 MB |
|
MAC Address Table Size |
128 MAC |
|
Voltage Required |
AC: Rated voltage range: 100V to 240V, 50/60 Hz Maximum voltage range: 90V to 264V, 47 Hz/63 Hz |
|
Power Device |
A AC power supply |
|
Power Consumption Operational |
Without PD: < 188.74W, |
|
Forwarding performance |
192 Mpps |
|
Switching capacity |
598 Gbit/s |
|
Dimensions (W x D x H) |
442 mm x 420 mm x 44.4 mm |
|
Weight |
10.6 kg |
Детали продукта
На рисунке 2 показана передняя панель Huawei S5720-56C-HI-AC switch.
Note:
|
? |
Forty-eight 10/100/1000BASE-T ports |
? |
Four 10GE SFP+ ports |
|
? |
USB port |
? |
USB port |
|
? |
One mini USB port |
? |
ETH management port |
На рисунке 3 показана задняя панель Huawei S5720-56C-HI-AC switch.
Note:
|
? |
Ground screw |
? |
ESN label |
|
? |
Rear card slot 1 |
? |
Rear card slot 2 |
|
? |
Power module slot 2 |
? |
Power module slot 1 |
*The ground screw is used with a ground cable.
* You can draw the ESN label out to view the ESN and MAC address of the switch.
*Rear card slot 1 is a reserved stack card slot.
Recommended Modules
Table 2 shows the recommended modules.
|
Model |
Description |
|
10G-SFP+ Optical Transceiver |
|
|
SFP-10G-USR |
10GBase-USR Optical Transceiver, SFP+, 10G, Multi-mode Module(850nm,0.1km,LC) |
|
OMXD30000 |
Optical Transceiver, SFP+, 10G, Multi-mode Module(850nm,0.3km,LC) |
|
OSX010000 |
Optical Transceiver, SFP+, 10G, Single-mode Module(1310nm,10km,LC) |
|
Power Module
|
|
|
PAC-600WA-B |
600W AC Power Module(Back to Front, Power panel side exhaust) |
|
PDC-350WA-B |
350W DC Power Module(Back to Front, Power panel side exhaust) |
|
GE-SFP Optical Transceiver |
|
|
eSFP-GE-SX-MM850 |
Optical Transceiver, eSFP, GE, Multi-mode Module(850nm,0.55km,LC) |
|
SFP-GE-LX-SM1310 |
Optical Transceiver, eSFP, GE, Single-mode Module(1310nm,10km,LC) |
|
S-SFP-GE-LH40-SM1310 |
Optical Transceiver, eSFP, GE, Single-mode Module(1310nm,40km,LC) |
|
S-SFP-GE-LH40-SM1550 |
Optical Transceiver, eSFP, GE, Single-mode Module(1550nm,40km,LC) |
|
SFP-1000BaseT |
Electrical Transceiver, SFP, GE, Electrical Interface Module(100m,RJ45) |
Compare with Similar Item
Table 3 shows the comparison of Huawei S5720-56C-HI-AC and S5720-56C-PWR-HI-AC.
|
Models |
S5720-56C-HI-AC |
S5720-56C-PWR-HI-AC |
|
Fixed Ports |
48 x 10/100/1,000 Base-T, 4 x 10 GE SFP+ |
48 x 10/100/1,000 Base-T, 4 x 10 GE SFP+ |
|
Power Supply |
600W AC power supply
|
600W/1,150W AC power supply
|
|
Forwarding Performance |
192 Mpps |
192 Mpps |
|
Switching Capacity |
598 Gbit/s |
598 Gbit/s |
|
PoE |
NA |
Supported |
|
Power Consumption |
< 183.3W |
Without PD: < 188.74W, |
Comparison between LI, SI, EI and HI
Huawei S5720 Series Enterprise Switches provides LI (Lite), SI (Standard), EI (Enhanced) and HI (Hyper) models for users. There are some differences among these four versions.
Click this PDF to know more.
Comparison of Huawei S5720-LI, SI, EI and HI Series Switches.pdf
Get More Information
Do you have any question about the Huawei S5720-56C-HI-AC switch?
Свяжитесь с нами через ЧАТ или e-mail: info@itg-spb.ru.
| Specification | |
| Input voltage | AC: Rated voltage range: 100 V to 240 V AC, 50/60 Hz Maximum voltage range: 90 V to 264 V AC, 47/63 Hz DC: Rated voltage range: –48 V to –60 V, DC Maximum voltage range: –36 V to –72 V DC Note: PoE-support switches do not use DC power supplies. |
| Multicast | IGMP v1/v2/v3 snooping and IGMP fast leave Multicast forwarding in a VLAN and multicast replication between VLANs Multicast load balancing among member ports of a trunk Controllable multicast Port-based multicast traffic statistics IGMP v1/v2/v3, PIM-SM, PIM-DM, PIM-SSM, MSDP (supported by the S5700-EI/S5700-HI series) |
| Security | User privilege management and password protection DoS attack defense, ARP attack defense, and ICMP attack defense Binding of the IP address, MAC address, interface, and VLAN Port isolation, port security, and sticky MAC MFF Blackhole MAC address entries Limit on the number of learned MAC addresses 802.1x authentication and limit on the number of users on an interface AAA authentication, RADIUS authentication, HWTACACS authentication, and NAC SSH v2.0 Hypertext Transfer Protocol Secure (HTTPS) CPU defense Blacklist and whitelist |
| VLAN | 4K VLANs Guest VLAN and voice VLAN GVRP MUX VLAN VLAN assignment based on MAC addresses, protocols, IP subnets, policies, and ports 1:1 and N:1 VLAN Mapping SuperVLAN(supported by the S5700-SI/S5700-EI/S5700-HI series) |
| Ring protection | RRPP ring topology and RRPP multi-instance Smart Link tree topology and Smart Link multi-instance, providing the millisecond-level protection switchover SEP ERPS(G.8032)(supported by the S5700-LI/S5700-SI/S5700-EI/S5700-HI series) STP, RSTP, and MSTP BPDU protection, root protection, and loop protection BPDU Tunnel |
| MPLS features | MPLS L3VPN MPLS L2VPN(VPWS/VPLS) MPLS-TE MPLS QoS Notes: supported by S5710-EI, S5700-HI and S5710-HI |
| Management and maintenance | Virtual cable test Port mirroring and RSPAN (remote port mirroring) Remote configuration and maintenance using Telnet SNMP v1/v2c/v3 RMON Web NMS HGMP System logs and alarms of different levels 802.3az EEE (supported by the S5700(S)-LI, S5710-EI, S5700-HI and S5710-HI) Dying gasp (supported by the S5700-HI, S5710-HI and S5700(S)-LI(except battery LAN switches) NetStream (supported by the S5710-EI, S5700-HI and S5710-HI) sFlow(supported by the S5700(S)-LI/S5700-EI/S5700-HI series) |
| MAC address table | IEEE 802.1d compliance MAC address learning and aging Static, dynamic, and blackhole MAC address entries Packet filtering based on source MAC addresses MAC address entries: S5700S-LI series: 8K, S5700-LI/S5700-SI series: 16K, S5700-EI series: 32K, S5720-EI series: 64K, S5700-HI series: S5700-HI: 32K, S5710-HI: 456K, S5720-HI: 128K |
| IP routing | Static routing RIPv1, RIPv2 and RIPng,ECMP(supported by the S5700-SI/S5700-EI/S5700-HI series) OSPF, OSPFv3, IS-IS, IS-ISv6, BGP and BGP4+ (supported by the S5700-EI/S5700-HI series) |
| Interoperability | Supports VBST (Compatible with PVST/PVST+/RPVST) Supports LNP (Similar to DTP) Supports VCMP (Similar to VTP) |
| IPv6 features | Neighbor Discovery (ND) Path MTU (PMTU) IPv6 ping, IPv6 tracert, and IPv6 Telnet ACLs based on the source IPv6 address, destination IPv6 address, Layer 4 ports, or protocol type MLD v1/v2 snooping 6to4 tunnel, ISATAP tunnel, and manually configured tunnel(supported by the S5700-SI/S5700-EI/S5700-HI series) |
| Operating environment | Operating temperature: 0 –50 Relative humidity: 10%–90% (non-condensing) |
| Reliability | Ethernet OAM (IEEE 802.3ah and 802.1ag) ITU-Y.1731 DLDP LACP E-Trunk(supported by the S5700-SI/S5700-EI/S5700-HI series) BFD for OSPF, BFD for IS-IS, BFD for VRRP, and BFD for PIM (supported by the S5700-EI/S5700-HI series) |
| QoS/ACL | Rate limiting on packets sent and received by an interface Packet redirection Port-based traffic policing and two-rate three-color CAR Eight queues on each port WRR, DRR, SP, WRR+SP, and DRR+SP queue scheduling algorithms WRED (supported by the S5710-EI and S5700-HI) Re-marking of the 802.1p priority and DSCP priority Packet filtering at Layers 2 through 4, filtering out invalid frames based on the source MAC address, destination MAC address, source IP address, destination IP address, TCP/UDP port number, protocol type, and VLAN ID Rate limiting in each queue and traffic shaping on ports |
| Access Security | DHCP Relay, DHCP Server, DHCP Snooping, DHCP Security |
Теги: S5720-56C-HI-AC