+7 (812) 309 34 73. Договоримся!
Общая информация (S5700-52C-PWR-SI)
The S5700-52C-PWR-SI is gigabit Layer 3 Ethernet switch based on new generation of high-performance hardware and Huawei Versatile Routing Platform (VRP). With 48 GE ports(10/100/1000Base-T), it provides a large switching capacity and constant power supply for users based on special PoE function, applicable to various scenarios. Besides, the device can be equipped with multiple card modules to satisfy customers' different needs. The S5700-52C-PWR-SI integrates many advanced technologies in terms of reliability, security, and energy conservation in order to help enterprise customers build a next-generation IT network.
Быстрые спецификацииs
На рисунке 1 показан внешний вид Huawei S5700-52C-PWR-SI switch.
Таблица 1 показывает Быстрые спецификацииs.
|
Product Code |
S5700-52C-PWR-SI |
|
Ports |
48 × 10/100/1,000 Base-T |
|
Extended Slots |
2 extended slots, one for an uplink subcard and the other for a stack card. |
|
Memory (RAM) |
256 MB |
|
Flash |
32 MB |
|
MAC Address Table Size |
16 MAC |
|
Subcard Supported |
4 x 1,000 Base-X SFP subcard 2 x 10 GE SFP+ subcard 4 x 10 GE SFP+ subcard |
|
Voltage Required |
AC: Rated voltage range: 100V to 240V, 50/60 Hz Maximum voltage range: 90V to 264V, 50/60 Hz |
|
Power Device |
Do double hot-swappable AC power supplies |
|
Power Consumption Operational |
<917W (PoE: 740W) |
|
Forwarding performance |
132 Mpps |
|
Switching capacity |
256 Gbit/s |
|
Dimensions (W x D x H) |
442 mm x 420 mm x 43.6 mm |
|
Weight |
6.2 kg |
|
PoE |
Supported |
Детали продукта
На рисунке 2 показана передняя панель HuaweiS5700-52C-PWR-SI switch.
Note:
|
? |
Forty-eight PoE+ 10/100/1000BASE-T ports |
? |
Front card slot |
|
? |
USB port |
? |
ETH management port |
|
? |
One console port |
|
|
* The front card slot is equipped with the card module, but the card module should be purchased separately.
На рисунке 3 показана задняя панель Huawei S5700-52C-PWR-SI switch.
Note:
|
? |
ESD jack |
? |
Rear card slot |
|
? |
Fan slot |
? |
Power module slot 2 |
|
? |
Power module slot 1 |
|
|
*Ventilating fan, cards and power modules have been installed in the diagram, but they should be purchased alone.
*Before installingmaintaining a switch, wear an ESD wrist strap and insert the other end of the ESD wrist strap into this ESD jack.
Recommended Modules
Table 2 shows the recommended modules.
|
|
Model |
Description |
|
Power module |
W0PSA5000 |
500W AC Power Module(gray) |
|
Optical Transceivers |
OMXD30000 |
Optical Transceiver,SFP+,10G,Multi-mode Module(850nm,0.3km,LC) |
|
OSX010000 |
Optical Transceiver,SFP+,10G,Single-mode Module(1310nm,10km,LC) |
|
|
SFP-10G-USR |
10GBase-USR Optical Transceiver,SFP+,10G,Multi-mode Module(850nm,0.1km,LC) |
|
|
eSFP-GE-SX-MM850 |
Optical Transceiver, eSFP, GE, Multi-mode Module(850nm,0.5km,LC) |
|
|
eSFP-GE-ZX100-SM1550 |
eSFP, GE, Single-mode Module(1550nm,100km,LC) |
|
|
Copper Transceivers |
SFP-1000BaseT |
1000BASE-T (RJ45) SFP Electrical Module, Auto Negotiate,100m |
|
Card |
ES5D000X2S00 |
2 10 Gig SFP+ interface card(used in S5700SI and S5700EI series |
Compare with Similar Item
Table 3 shows the comparison of Huawei S5700-52C-SI, 5700-52C-SI-AC and S5700-52C-PWR-SI.
|
Models |
S5700-52C-SI |
S5700-52C-SI-AC |
S5700-52C-PWR-SI |
|
Fixed Ports |
48 x 10/100/1,000 Base-T |
48 x 10/100/1,000 Base-T |
48 x 10/100/1,000 Base-T |
|
Extended Slots |
2 extended slots, one for an uplink subcard and the other for a stack card |
2 extended slots, one for an uplink subcard and the other for a stack card |
2 extended slots, one for an uplink subcard and the other for a stack card |
|
Power Supply |
Double hot-swappable AC/DC |
Double hot-swappable AC/DC |
Double hot-swappable AC , PoE+ |
|
Forwarding Performance |
132 Mpps |
132 Mpps |
132 Mpps |
|
Switching Capacity |
256 Gbit/s |
256 Gbit/s |
256 Gbit/s |
|
Power Consumption |
< 78W |
< 78W |
< 917W (PoE: 740W) |
Comparison between LI, SI, EI and HI
Huawei S5700 Series Enterprise Switches provides LI (Lite), SI (Standard), EI (Enhanced) and HI (Hyper) models for users. There are some differences among these four versions.
Click this PDF to know more.
Comparison of Huawei S5700-LI, SI, EI and HI Series Switches.pdf
Get More Information
Do you have any question about the Huawei S5700-52C-PWR-SI switch?
Свяжитесь с нами через ЧАТ или e-mail: info@itg-spb.ru.
| Specification | |
| Input voltage | AC: Rated voltage range: 100 V to 240 V AC, 50/60 Hz Maximum voltage range: 90 V to 264 V AC, 47/63 Hz DC: Rated voltage range: –48 V to –60 V, DC Maximum voltage range: –36 V to –72 V DC Note: PoE-support switches do not use DC power supplies. |
| Multicast | IGMP v1/v2/v3 snooping and IGMP fast leave Multicast forwarding in a VLAN and multicast replication between VLANs Multicast load balancing among member ports of a trunk Controllable multicast Port-based multicast traffic statistics IGMP v1/v2/v3, PIM-SM, PIM-DM, PIM-SSM, MSDP (supported by the S5700-EI/S5700-HI series) |
| Security | User privilege management and password protection DoS attack defense, ARP attack defense, and ICMP attack defense Binding of the IP address, MAC address, interface, and VLAN Port isolation, port security, and sticky MAC MFF Blackhole MAC address entries Limit on the number of learned MAC addresses 802.1x authentication and limit on the number of users on an interface AAA authentication, RADIUS authentication, HWTACACS authentication, and NAC SSH v2.0 Hypertext Transfer Protocol Secure (HTTPS) CPU defense Blacklist and whitelist |
| VLAN | 4K VLANs Guest VLAN and voice VLAN GVRP MUX VLAN VLAN assignment based on MAC addresses, protocols, IP subnets, policies, and ports 1:1 and N:1 VLAN Mapping SuperVLAN(supported by the S5700-SI/S5700-EI/S5700-HI series) |
| Ring protection | RRPP ring topology and RRPP multi-instance Smart Link tree topology and Smart Link multi-instance, providing the millisecond-level protection switchover SEP ERPS(G.8032)(supported by the S5700-LI/S5700-SI/S5700-EI/S5700-HI series) STP, RSTP, and MSTP BPDU protection, root protection, and loop protection BPDU Tunnel |
| MPLS features | MPLS L3VPN MPLS L2VPN(VPWS/VPLS) MPLS-TE MPLS QoS Notes: supported by S5710-EI, S5700-HI and S5710-HI |
| Management and maintenance | Virtual cable test Port mirroring and RSPAN (remote port mirroring) Remote configuration and maintenance using Telnet SNMP v1/v2c/v3 RMON Web NMS HGMP System logs and alarms of different levels 802.3az EEE (supported by the S5700(S)-LI, S5710-EI, S5700-HI and S5710-HI) Dying gasp (supported by the S5700-HI, S5710-HI and S5700(S)-LI(except battery LAN switches) NetStream (supported by the S5710-EI, S5700-HI and S5710-HI) sFlow(supported by the S5700(S)-LI/S5700-EI/S5700-HI series) |
| MAC address table | IEEE 802.1d compliance MAC address learning and aging Static, dynamic, and blackhole MAC address entries Packet filtering based on source MAC addresses MAC address entries: S5700S-LI series: 8K, S5700-LI/S5700-SI series: 16K, S5700-EI series: 32K, S5720-EI series: 64K, S5700-HI series: S5700-HI: 32K, S5710-HI: 456K, S5720-HI: 128K |
| IP routing | Static routing RIPv1, RIPv2 and RIPng,ECMP(supported by the S5700-SI/S5700-EI/S5700-HI series) OSPF, OSPFv3, IS-IS, IS-ISv6, BGP and BGP4+ (supported by the S5700-EI/S5700-HI series) |
| Interoperability | Supports VBST (Compatible with PVST/PVST+/RPVST) Supports LNP (Similar to DTP) Supports VCMP (Similar to VTP) |
| IPv6 features | Neighbor Discovery (ND) Path MTU (PMTU) IPv6 ping, IPv6 tracert, and IPv6 Telnet ACLs based on the source IPv6 address, destination IPv6 address, Layer 4 ports, or protocol type MLD v1/v2 snooping 6to4 tunnel, ISATAP tunnel, and manually configured tunnel(supported by the S5700-SI/S5700-EI/S5700-HI series) |
| Operating environment | Operating temperature: 0 –50 Relative humidity: 10%–90% (non-condensing) |
| Reliability | Ethernet OAM (IEEE 802.3ah and 802.1ag) ITU-Y.1731 DLDP LACP E-Trunk(supported by the S5700-SI/S5700-EI/S5700-HI series) BFD for OSPF, BFD for IS-IS, BFD for VRRP, and BFD for PIM (supported by the S5700-EI/S5700-HI series) |
| QoS/ACL | Rate limiting on packets sent and received by an interface Packet redirection Port-based traffic policing and two-rate three-color CAR Eight queues on each port WRR, DRR, SP, WRR+SP, and DRR+SP queue scheduling algorithms WRED (supported by the S5710-EI and S5700-HI) Re-marking of the 802.1p priority and DSCP priority Packet filtering at Layers 2 through 4, filtering out invalid frames based on the source MAC address, destination MAC address, source IP address, destination IP address, TCP/UDP port number, protocol type, and VLAN ID Rate limiting in each queue and traffic shaping on ports |
| Access Security | DHCP Relay, DHCP Server, DHCP Snooping, DHCP Security |
Теги: S5700-52C-PWR-SI