+7 (812) 309 34 73. Договоримся!
Общая информация (S5720-56C-PWR-HI-AC1)
Huawei S5720-56C-PWR-HI-AC1 is advanced Gigabit Ethernet switch that provides rich agile features, based on Huawei Versatile Routing Platform (VRP). With forty-eight Ethernet 10/100/1,000 ports, and four 10 Gig SFP+, the switch provides the ubiquitous service function to ensure consistent user experience, what's more, the special PoE function guarantees constant power supply to meet customers' electricity demand. The Super Virtual Fabric (SVF) function virtualizes the entire network into one device. In addition, the switch supports flexible Ethernet networking, comprehensive VPN tunnel solutions, various security control methods, intelligent deployment, and simple operation and maintenance. The S5720-56C-PWR-HI-AC1 switch is the best choice for the branches of high-quality large- and middle-sized campus networks.
Быстрые спецификацииs
На рисунке 1 показан внешний вид Huawei S5720-56C-PWR-HI-AC1 switch.
Таблица 1 показывает Быстрые спецификацииs.
|
Product Code |
S5720-56C-HI-AC1 |
|
Ports |
- 48 x 10/100/1,000 Base-T, - 4 x 10 GE SFP+ |
|
Memory (RAM) |
4 GB |
|
Flash |
400 MB |
|
MAC Address Table Size |
128 MAC |
|
Voltage Required |
AC: Rated voltage range: 100V to 240V, 50/60 Hz Maximum voltage range: 90V to 264V, 47 Hz/63 Hz |
|
Power Device |
A 550W AC power supply |
|
Power Consumption Operational |
Without PD: < 188.74W, |
|
Forwarding performance |
192 Mpps |
|
Switching capacity |
598 Gbit/s |
|
Dimensions (W x D x H) |
442 mm x 420 mm x 44.4 mm |
|
Weight |
10.6 kg |
Детали продукта
На рисунке 2 показана передняя панель Huawei S5720-56C-PWR-HI-AC1 switch.
Note:
|
? |
Forty-eight PoE+ 10/100/1000BASE-T ports |
? |
Four 10GE SFP+ ports |
|
? |
USB port |
? |
USB port |
|
? |
One mini USB port |
? |
ETH management port |
*The ground screw is used with a ground cable.
* You can draw the ESN label out to view the ESN and MAC address of the switch.
*Rear card slot 1 is a reserved stack card slot.
In the back panel of S5720-56C-PWR-HI-AC1 switch, there are ground screw, ESN label, two rear card slots and two power module slots. The ground screw should be used with a ground cable, and you can draw the ESN label out to view the ESN and MAC address of the switch. One rear card slot is a reserved stack card slot.
Recommended Modules
Table 2 shows the recommended modules.
|
Category |
Model |
Description |
|
10G-SFP+ Optical Transceiver |
SFP-10G-USR |
10GBase-USR Optical Transceiver, SFP+, 10G, Multi-mode Module(850nm,0.1km,LC) |
|
OMXD30000 |
Optical Transceiver, SFP+, 10G, Multi-mode Module(850nm,0.3km,LC) |
|
|
OSX010000 |
Optical Transceiver, SFP+, 10G, Single-mode Module(1310nm,10km,LC) |
|
|
Power Module |
W2PSA0580 |
580W AC power module |
|
GE-SFP Optical Transceiver |
eSFP-GE-SX-MM850 |
Optical Transceiver, eSFP, GE, Multi-mode Module(850nm,0.55km,LC) |
|
SFP-GE-LX-SM1310 |
Optical Transceiver, eSFP, GE, Single-mode Module(1310nm,10km,LC) |
|
|
S-SFP-GE-LH40-SM1310 |
Optical Transceiver, eSFP, GE, Single-mode Module(1310nm,40km,LC) |
|
|
S-SFP-GE-LH40-SM1550 |
Optical Transceiver, eSFP, GE, Single-mode Module(1550nm,40km,LC) |
|
|
SFP-1000BaseT |
Electrical Transceiver, SFP, GE, Electrical Interface Module(100m,RJ45) |
Compare with Similar Item
Table 3 shows the comparison of Huawei S5720-56C-HI-AC and S5720-56C-PWR-HI-AC1.
|
Models |
S5720-56C-HI-AC |
S5720-56C-PWR-HI-AC1 |
|
Fixed Ports |
48 x 10/100/1,000 Base-T, 4 x 10 GE SFP+ |
48 x 10/100/1,000 Base-T, 4 x 10 GE SFP+ |
|
Power Supply |
600W AC power supply |
600W / 1150W AC power supply |
|
Forwarding Performance |
192 Mpps |
192 Mpps |
|
Switching Capacity |
598 Gbit/s |
598 Gbit/s |
|
PoE |
NA |
Supported |
|
Power Consumption |
< 183.3W |
Without PD: < 188.74W, |
Comparison between LI, SI, EI and HI
Huawei S5720 Series Enterprise Switches provides LI (Lite), SI (Standard), EI (Enhanced) and HI (Hyper) models for users. There are some differences among these four versions.
Click this PDF to know more.
Comparison of Huawei S5720-LI, SI, EI and HI Series Switches.pdf
Что бы получить больше информации
У вас есть какие-либо вопросы о Huawei S5720-56C-PWR-HI-AC1 switch?
Свяжитесь с нами через ЧАТ или e-mail: info@itg-spb.ru.
| Specification | |
| OAM | EFM OAM CFM OAM Y.1731 performance monitoring |
| iPCA | Directly coloring service packets to collect real-time statistics on the number of lost packets and packet loss ratio Collection of statistics on the number of lost packets and packet loss ratio at network and device levels |
| Dimensions (W x D x H) | 442.0 mm x 420.0 mm x 44.4 mm When a 1,150W power module is installed, it extrudes out from the chassis. Therefore, the total depth of the switch changes to 507 mm |
| Multicast | IGMPv1/v2/v3 snooping and IGMP prompt leave Multicast forwarding in a VLAN and multicast replication between VLANs Multicast load balancing among member ports of a trunk Controllable multicast Port-based multicast traffic statistics collection IGMPv1/v2/v3, PIM-SM, PIM-DM, and PIM-SSM MSDP |
| Security | Hierarchical user management and password protection DoS attack defense, ARP attack defense, and ICMP attack defense Binding of the IP address, MAC address, interface number, and VLAN ID Port isolation, port security, and sticky MAC MAC Forced Forwarding (MFF) Blackhole MAC address entries Limitation on the number of learned MAC addresses IEEE 802.1x authentication and limitation on the number of users on a port AAA authentication, RADIUS authentication, HWTACACS authentication, and NAC SSH V2.0 HTTPS CPU protection Blacklist and whitelist DHCP relay/server/snooping/client/security MACSec |
| VLAN | 4K VLANs Guest VLAN, Voice VLAN GVRP MUX VLAN VLAN assignment based on MAC addresses, protocols, IP subnets, policies, and ports VLAN mapping |
| Input Voltage | AC rated voltage: 100V to 240V, 50 Hz/60 Hz Maximum voltage range: 90V to 264V, 47 Hz/63 Hz |
| Power Consumption | Without PD: < 188.74W, With PD: < 1,739W (device: 299W, PD: 1,440W) |
| Extended Slots | One port extended slot with optional subcard 4 x 10 GE SFP+ One slot reserved for the stack card |
| Super Virtual Fabric (SVF) | Working as the parent node to vertically virtualize downlink switches and APs as one device for management Supports a two-layer client architecture |
| Management and Maintenance | iStack Virtual Cable Test SNMPv1/v2c/v3 RMON Network management system (NMS) and Web management System logs and multi-level alarms GVRP MUX VLAN 802.3az Energy Efficient Ethernet (EEE) NetStream Dying Gasp upon power-off |
| Interoperability | VLAN-Based Spanning Tree (VBST), working with PVST, PVST+, and RPVST Link-type Negotiation Protocol (LNP), similar with DTP VLAN Central Management Protocol (VCMP), similar with VTP |
| Operating Environment | Operating temperature: 0°C to 45°C Relative humidity: 5% to 95% (non-condensing) |
| Fixed Ports | 48 x 10/100/1,000 Base-T, 4 x 10 GE SFP+ |
| MAC Address Table | IEEE 802.1d standards compliance 128K MAC address entries MAC address learning and aging Static, dynamic, and blackhole MAC address entries Packet filtering based on source MAC addresses |
| Reliability | RRPP ring topology and RRPP multi-instance Smart Link tree topology and Smart Link multi-instance, providing the millisecond-level protection switchover SEP G.8032 Ethernet Ring Protection Switching (ERPS) BFD for OSPF, BFD for IS-IS, BFD for VRRP, and BFD for PIM STP (IEEE 802.1d), RSTP (IEEE 802.1w), and MSTP (IEEE 802.1s) BPDU protection, root protection, and loop protection |
| IP Routing | Static routes, RIPv1/v2, RIPng, OSPF, OSPFv3, IS-IS, IS-ISv6, BGP, BGP4+, ECMP, and routing policy |
| IPv6 Features | Neighbor Discover (ND) PMTU IPv6 Ping, IPv6 Tracert, IPv6 Telnet ACLs based on source IPv6 addresses, destination IPv6 addresses, Layer 4 ports, or protocol types Multicast Listener Discovery snooping (MLDv1/v2) |
| QoS/ACL | Rate limitation in the inbound and outbound directions of a port Packet redirection Port-based traffic policing and two-rate and three-color CAR Eight queues on each port DRR, SP and DRR + SP queue scheduling algorithms WRED HQoS Re-marking of the 802.1p and DSCP fields of packets Packet filtering on Layer 2 to Layer 4, filtering out invalid frames based on the source MAC address, destination MAC address, source IP address, destination IP address, TCP/UDP source/destination port number, protocol number, or VLAN Queue-based rate limitation and shaping on ports |
| MPLS | MPLS L3VPN MPLS L2VPN (VPWS/VPLS) MPLS-TE MPLS QoS |
| Wireless AC | AP access control, AP domain management, and AP configuration template management Radio frequency management, unified static configuration, and dynamic centralized management WLAN basic services, QoS, security, and user management CAPWAP, Tag/terminal location, and spectrum analysis |
Теги: S5720-56C-PWR-HI-AC1