+7 (812) 309 34 73. Договоримся!
Общая информация (S3700-28TP-EI-24S-AC)
Huawei S3700-28TP-EI-24S-AC is next-generation Layer 3 Ethernet switch that supports IP multicasting and complex routing protocols. It delivers 24 FE SFP, 2 Gig SFP and 2 dual-purpose 10/100/1000SFP.
Быстрые спецификацииs
На рисунке 1 показан внешний вид Huawei S3700-28TP-EI-24S-AC switch.
Таблица 1 показывает Быстрые спецификацииs.
Product Code |
S3700-28TP-EI-24S-AC |
Downlink Ports |
24 x 100 Base-FX SFP ports |
Uplink Ports |
2 x 1000BASE-X 2 x Combo (10/100/1000BASE-T100/1000BASE-X) |
MAC Address |
16K MAC |
VLAN |
4K VLANs |
Forwarding Performance |
9.6 Mpps |
Switching Capacity |
64 Gbit/s |
Stacking |
Supported |
Stack Connection Mode |
Service port connection |
Power |
AC power supply |
Heat Dissipation |
Forced air cooling |
Installation mode |
Rack mounting, desk mounting, wall mounting |
300-mm deep cabinet |
Supported |
Dimensions (W x D x H) |
44.2 cm x 22 cm x 4.36 cm |
Детали продукта
На рисунке 2 показана передняя панель Huawei S3700-28TP-EI-24S-AC switch.
Note:
? |
Ground Screw |
? |
2 x 1000BASE-X Ethernet optical interfaces |
? |
AC Power Socket |
? |
2 x Gigabit Combo Ports |
? |
Power Switch |
? |
One Console Port |
? |
24 x 100BASE-X |
·Ground Screw is used with a ground cable.
·AC Power Socket is used with AC Power cables
·Two Combo Ports include 10/100/1000BASE-T and 100/1000BASE-X ports. FE/GE/GE-CWDM optical transceivers are applicable to the combo ports.
·Huawei S3700-28TP-EI-24S-AC switch supports Huawei Intelligent Stack Technology (iStack). Multiple S3700 switches can be connected with stack cables to set up a stack, which functions as a virtual switch.
Figure 3 shows the back looking of Huawei S3700-28TP-EI-24S-AC switch.
The Transceiver
Table 2 shows the recommended optical transceivers.
Model |
Description |
FE-SFP Optical Transceiver |
|
SFP-FE-SX-MM1310 |
Optical Transceiver,SFP,100M/155M,Multi-mode Module(1310nm,2km,LC) |
eSFP-FE-LX-SM1310 |
Optical Transceiver,eSFP,100M/155M,Single-mode Module(1310nm,15km,LC) |
S-SFP-FE-LH40-SM1310 |
Optical Transceiver, eSFP, FE, Single-mode Module(1310nm,40km,LC) |
GE-SFP Optical Transceiver |
|
SFP-1000BaseT |
Electrical Transceiver, SFP, GE, Electrical Interface Module(100m,RJ45) |
eSFP-GE-SX-MM850 |
Optical Transceiver, eSFP, GE, Multi-mode Module(850nm,0.55km,LC) |
SFP-GE-LX-SM1310 |
Optical Transceiver, eSFP, GE, Single-mode Module(1310nm,10km,LC) |
S-SFP-GE-LH40-SM1310 |
Optical Transceiver, eSFP, GE, Single-mode Module(1310nm,40km,LC) |
S-SFP-GE-LH40-SM1550 |
Optical Transceiver, eSFP, GE, Single-mode Module(1550nm,40km,LC) |
Сравнение с аналогом
Table 3 shows the comparison of Huawei S3700-52P-EI-24S-AC and S3700-28TP-EI-24S-AC.
Models |
S3700-52P-EI-24S-AC |
S3700-28TP-EI-24S-AC |
Downlink Ports |
24 x 10/100 Base-TX ports 24 x 100 Base-FX SFP ports |
24 x 100 Base-FX SFP ports |
Uplink Ports |
2 x 100/1,000 Base-X SFP ports, and 2 x 1,000 Base-X SFP ports |
2 x 1,000 Base-X SFP ports, and 2 x gigabit combo ports (10/100/1,000 Base-T100/1,000 Base-X) |
Power Supply |
AC Power Supply |
AC Power Supply |
Что бы получить больше информации
У вас есть какие-либо вопросы о Huawei S3700-28TP-EI-24S-AC switch?
Свяжитесь с нами через ЧАТ или e-mail: info@itg-spb.ru.
Specification | |
Dimensions (W x D x H) | 442 mm x 220 mm x 43.6 mm |
Multicast | 1 K multicast groups IGMP v1/v2/v3 snooping and IGMP fast leave Multicast VLAN and multicast replication between VLANs Multicast load balancing among member ports of a trunk Controllable multicast Port-based multicast traffic statistics |
Power consumption | S3700-28TP-EI-24S<52W |
Security | User privilege management and password protection DoS attack defense, ARP attack defense, and ICMP attack defense Binding of the IP address, MAC address, interface, and VLAN Port isolation, port security, and sticky MAC Blackhole MAC address entries Limit on the number of learned MAC addresses 802.1x authentication and limit on the number of users on an interface AAA authentication, RADIUS authentication, HWTACACS authentication, and NAC SSH v2.0 CPU defense Blacklist and whitelist |
VLAN | 4K VLANs Guest VLANs, voice VLAN, and super VLAN MUX VLAN and GVRP VLAN assignment based on MAC addresses, protocols, and IP subnets QinQ Selective QinQ 1:1 VLAN mapping N:1 VLAN mapping |
Power supply | AC: Rated voltage range: 100V to 240V AC; 50/60 Hz Maximum voltage range: 90V to 264V AC; 50/60 Hz |
Weight | S3700-28TP-EI-24S<2.6Kg |
Management and maintenance | iStack MAC Forced Forwarding (MFF) Remote configuration and maintenance using Telnet Auto-Config Virtual cable test Ethernet OAM (IEEE 802.3ah and 802.1ag) Dying gasp power-off alarm (S3700-28TP-EI-MC-AC) SNMP v1/v2c/v3 and RMON Web NMS |
MAC address table | IEEE 802.1d compliance 16K MAC address entries MAC address learning and aging Static, dynamic, and blackhole MAC address entries Packet filtering based on source MAC addresses |
IP routing | Static routing, RIPv1, RIPv2, and ECMP |
IPv6 features | Neighbor Discovery (ND) Path MTU (PMTU) IPv6 ping, IPv6 tracert, and IPv6 Telnet Manually configured tunnel 6to4 tunnel ISATAP tunnel ACLs based on the source IPv6 address, destination IPv6 address, Layer 4 ports, or protocol type MLD v1/v2 snooping |
Surge protection | 6KV surge protection capability on service ports (1KV on service ports on PoE devices) |
Operating environment | Operating temperature: 0 –50 (long term); Relative humidity: 10%–90% (non-condensing) |
Reliability | RRPP (ring topology, intersecting rings, and multi-instance), implementing protection switchover within 50 ms Smart Link tree topology and Smart Link multi-instance, providing the millisecond-level protection switchover STP(IEEE 802.1d), RSTP(IEEE 802.1w), and MSTP(IEEE 802.1s) BPDU protection, root protection, and loop protection Smart Ethernet Protection (SEP) |
QoS/ACL | Rate limiting on packets sent and received by an interface Packet redirection Port-based traffic policing and two-rate three-color CAR Eight queues on each port WRR, DRR, SP, WRR+SP, and DRR+SP queue scheduling algorithms Re-marking of the 802.1p priority and DSCP priority Packet filtering on Layers 2 through 4, filtering out invalid frames based on the source MAC address, destination MAC address, source IP address, destination IP address, port number, protocol type, and VLAN ID Rate limiting in each queue and traffic shaping on ports |
Ports description | 24*100Base-FX |