+7 (812) 309 34 73

по будням с 10:00 до 18:00

AIR-AP1810W-Q-K9

Производитель: Cisco
Код товара: AIR-AP1810W-Q-K9 - Cisco Aironet 1810W Access Point
Артикул: ART13467
По запросу
Сроки: 14 дней
Нашли дешевле?

+7 (812) 309 34 73. Договоримся!

Specification
Bluetooth (future availability) Integrated Bluetooth 4.1 (including BLE) radio
Maximum transmit power: 5 dBm
Antenna gain: 2 dBi
Integrated antennas 2.4 GHz, gain 2 dBi
5 GHz, gain 4 dBi
System 512 MB DRAM
256 MB flash
1.4 GHz system dual-core CPU
Physical security Torx security screw, included with the access point
Kensington security slot
Authentication and security Advanced Encryption Standard (AES) for Wi-Fi Protected Access 2 (WPA2)
802.1X, RADIUS authentication, authorization and accounting (AAA)
802.11i
Maximum clients Maximum number of associated wireless clients: 200 per Wi-Fi radio, in total 400 clients per access point
802.11ac 2x2 single-user/multiuser MIMO with two spatial streams
Maximal ratio combining (MRC)
20-, 40- and 80-MHz channels
PHY data rates up to 866.7 Mbps (80 MHz on 5 GHz)
Packet aggregation: A-MPDU (Tx/Rx), A-MSDU (Rx)
802.11 Dynamic Frequency Selection (DFS)
Cyclic shift diversity (CSD) support
Accessories Mounting bracket: AIR-AP-BRACKET-W2= (available as spare)
Spacer kit: AIR-AP1810W-KIT= (sold separately), includes spacer and RJ-45 jumper cable
Cradle kit: AIR-OEAP1810-CRD= (sold separately), includes back cover and RJ-45 jumper cable
Physical security kit: AIR-SEC-50= (sold separately), with 50 pcs. security screws used to secure the access point onto wall-mounting bracket, 50 pcs. RJ-45 caps and 2 pcs. unlock keys used to block physical access to Ethernet ports
Cisco local power supply: AIR-PWR-D= (sold separately)
Powering options 802.3af/at Ethernet switch
Optional Cisco power injectors (AIR-PWRINJ5=, AIR-PWRINJ6=)
Optional Cisco local power supply (AIR-PWR-C= or AIR-PWR-D=)
Dimensions (W x L x H) Access point (without mounting bracket): 6.5 x 4.5 x 1.6 in. (165 x 114 x 41 mm)
Input power requirements 44 to 57V DC
Optional power supply and power injector: 100 to 240V AC; 49 to 60 Hz
Warranty Limited Lifetime Hardware Warranty
Power draw Maximum values: 12.95W (15.4W with 100m of cable) with no PoE out, 20.7W (22W with 100m of cable) with 6.49W PoE out and 27.65W with 12.95W PoE out (when powered using AIR-PWR-C or AIR-PWR-D)
Note: When deployed using PoE, the power draw numbers listed above include the power loss in 100m of cabling on the uplink port and 100m of cabling on the PoE out port.
Ethernet ports Authentication with 802.1X or MAC filtered
Dynamic VLAN or per port
Traffic locally switched or tunneled back to wireless LAN controller
Software Cisco Unified Wireless Network Software with AireOS Wireless Controllers Release 8.2.111.0 or later
Indicators Status LED indicates boot loader status, association status, operating status, boot loader warnings, boot loader errors
Per-port status for local Ethernet ports
For privacy, LEDs are automatically turned off when the access point joins a controller. LEDs may be enabled to be administratively - see configuration guide.
Mounting Included with the access point: mounting bracket AIR-AP-BRACKET-W2, compatible to install to single gang junction box or multiple international standards
Optional:
AIR-AP1810W-KIT=, spacer kit to mount the access point directly on a wall where standard junction boxes are not available
AIR-OEAP1810-CRD=, cradle kit to mount the access point on a desk
Environmental Nonoperating (storage) temperature: -22° to 158°F (-30° to 70°C)
Nonoperating (storage) maximum altitude: 25°C, 15,000 ft (4,500m)
Operating temperature: 32° to 104°F (0° to 40°C)
Operating humidity: 10% to 90% percent (noncondensing)
Operating maximum altitude: 40°C, 9843 ft (3,000m)
Interfaces One 10/100/1000BASE-T PoE uplink port
Management console port (RJ-45)
Three 10/100/1000BASE-T ports (local Ethernet ports), including one PoE out port:
PoE out provides 802.3af when access point is powered by Cisco local power supply (AIR-PWR-C=, AIR-PWR-D=), or ~6.5W when powered by 802.3at, or no output when powered by 802.3af
One passive pass-through port RJ-45 (back to bottom)
DC power connector
Weight Access point without mounting bracket or any other accessories: 1.2 lb (560 g)
  Написать отзыв